Glue-on single XLarge PVC handle for inflatable boats comes in light gray with a light gray handle or white with a light gray handle. Dimensions are a beefy 13.5″ x 4″. This is the largest handle and handle base on the market providing the most surface area for gluing for maximum safety, longevity and ease of use. No need to worry that your handle will fail if someone is trying to pull themselves into the boat. Made in the USA. Glues listed in related products below. We recommend the Weaver 2 part PVC glue for this application. See related products below for the required adhesives and solvents.
PVC handle installation instructions:
-
- Decide where you’re going to place the handle then trace around handle with a pencil.
-
-
Apply masking tape or painting tape around the traced area.
-
-
-
Sand the boat as well as the handle lightly and clean the area well using MEK
-
-
-
Apply 3 applications of glue (2 on boat, one on handle) allowing each application to become tacky (roughly 15 minutes).
-
-
-
Stick the handle down to boat and roll out the bubbles with a roller rasp.
-
-
-
Allow to dry for 24 hours.
-
Reviews
There are no reviews yet.