Inflatable boat molded glue-on grab handle used on most AB Inflatables and other brands of Hypalon inflatable boats.
- Molded EPDM rubber which is the only type of material that sticks to Hyalon/CSM fabric.
- 11-13/16″ long x 4-3/4″ wide.
- AB Part #AB85026-0010.
- Order 2-part Hypalon glue and Toluol solvent separately (See related products below).
- Available in Gray, White or Black.
Handle Installation Instructions:
- If removing old handle, use Toluol and hair dryer to remove.
- Also, remove old adhesive with Toluol.
- Sand area of boat where handle will be installed. Clean with Toluol again.
- Apply 3 thin layers of Hypalon glue, allowing each layer to become tacky (approx. 20 minutes).
- Stick Handle to boat and allow 24 hours to dry.