Weaver 2 Part PVC Adhesive, 1 Liter (33.8 ounces)
- Our Weaver 2-Part PVC Adhesive and solvents are rotated quickly and stored in an air-conditioned and heated facility in order to guarantee freshness and effectiveness!
- Weaver PVC 2-Part adhesive can be used for gluing on rubber pads, attaching lifting rings, and making repairs to inflatables made from Hypalon material.
- Important Shipping information: Adhesives, solvents, Liquid Rubber, and bottom paints are considered regulated material, and can only be shipped via ground transportation. Also, hazardous materials can not be shipped via the United States Postal service Priority mail. Therfore, hazardous materials can only be shipped via the United States Postal Service Parcel Select, or UPS ground. The Parcel Select service may delay delivery up to 7 days. The fastest method for shipping regulated material is UPS Ground so please choose that option during check-out if you are in a time sensitive position.
- The activator/curing agent will last approximately 30 days after opening. Once the 2 parts are combined, you will have 6 hours before the glue begins to harden.
- 2-Part glues are very effective but are slightly more difficult to work with and have a shorter shelf life than single part glues.
- MEK solvent is necessary for a successful repair. See related products below.
- Stiff brushes and roller rasps are listed in related products below.
- Unopened glue will last one year.
Instructions:
- 1. Use PVC glue in a well ventilated area. Do not use in high humidity, rain, direct sun, or near the water. We recommend making sure the humidity level is nothing higher than 60%.
- 2. If possible, the tube should be inflated while gluing.
- 3. Prep the surface of the PVC inflatable with MEK solvent to soften the fabric. Do not scrub the surface, just wipe the surface clean.
- 4. Mix all of the curing agent thoroughly into the adhesive for 2-3 minutes.
- 5. Apply a thin coat of adhesive to each surface (the accessory and the inflatable) and allow 5-15 minutes, or until the glued surfaces feel tacky.
- 6. Repeat step 5
- 7. Bring the two coated surfaces together using sufficient pressure with your hands to ensure contact. Make sure not to create any air pockets, or use a roller rasp (see related products below) to force out any air pockets under the pad or patch.
- 8. Allow to set for at least 48 hours.
