We are not required to collect sales & use tax on deliveries to addresses outside New Jersey. You may be responsible for payment of tax in your state if otherwise required or upon initial registration of your boat.

$7.95 flat rate shipping! No code needed
Most orders placed by 3pm EST ship same day
1/4-Liter 2-Part Weaver Hypalon Glue for Hypalon Inflatable Boats, Single 1/4 Liter

Inflatable Boat Adhesive, Hypalon Boats, Weaver 2 Part 1/4 Liter

Product Options:

  • Buy 4 for $35.45 each and save 7%

Price $37.95


Our glues and solvents are rotated quickly and stored in an air-conditioned and heated facility in order to guarantee freshness and effectiveness!   
Weaver Hypalon 2 part adhesive, 8 ounce, for gluing on rubber pads, adding lifting rings and making repairs to inflatables made from Hypalon material. Important Shipping information: Adhesive, MEK,Toluol, Liquid Rubber, and bottom paint is considered regulated material.  It can only be shipped via ground transportation.It cannot be shipped via the United States Postal serivce Priority mail. If you choose Priority Mail as a shipping method, it will be shipped via the United States Postal Service Parcel Select, this service may delay delivery up to 7 days.  The fastest method for shipping regulated material is UPS Ground.
The activator/curing agent will last approximately 7 days after opening.  2 part glues are very effective but are slightly more difficult to work with and have a shorter shelf life.    Once the 2 parts are mixed together, you will have a 5-6 hour working time before the glue begins to harden. Our Shore single part glue will last 1 month after opening. For ToobSeal Interior Repair Sealant, Shore Adhesive, Orange Off Cleaner and Adhesive remover and Toluol,  see related products below.  
Unopened, the glue will last one year.
Instructions for using Weaver 2 part adhesive:
1.  Prep the surface of the inflatable by abrading it with a clean emery cloth.  Next take a clean rag and use Toluene or Orange-Off cleaner to remove surface contamination.  It is important that the inflatable is clean and dry. 
2.  Mix the curing agent A100-10 thoroughly into the adhesive for 2-3 minutes in the amount supplied.
3.  Apply a thin coat of adhesive to each surface and allow 5-15 minutes or until the glued surface is dry to the touch. Reaaply another thin layer of glue to each surface.  When the surfaces get tacky, stick the parts to the inflatable.
4.  Bring the two coated surfaces together using sufficient pressure to ensure intimate contact, taking care not to create any air pockets under the pad, D ring or patch. 
5.  Let your glued parts set for at least 48 hours before utilizing. 
6.  Use glue in a well ventilated area.  Do not use in high humidity, in the rain, direct sun or near the water.  It is recommended that the humidity level not be above 60%. 

Additional Information

part number No
Choose Single 1/4 Liter
Choose Dinghy Model No
Choose Dinghy Model No
Select Fabric No
Choose Boat Model No
Choose Boat Model No
Boat Model No
Choose Quart/Gallon No
Valve Model No
Choose No
Bracket Size No
Choose Color No
Smart Tab SX Kits No
Model Number No
Choose Fabric No
Choose Diameter No
Feet No
Choose Length No
Sunbrella Colors No
Model No
Sharkskin Colors No
Colors No
Width No
Mounting Option No
Choose Size No
Manufacturer No